youtube how to use a software lag switch

For more information on switchport, see HOW10706. Hybrid Switchport on a Port channel Hybrid switchport is recommended for port channels. The below example shows removing VLAN 2 tagged from port Te 0/10:Īfter all the non-default VLANs are removed from the interface, the VLAN error will not appear.

If you receive 'Error: Te 0/10 Port is part of a non-default VLAN' error, there is VLAN configuration that has to be removed. The port is required to be in a default configuration when making the above changes. Firmware 9.9 or newer is required to use the 'default interface' command.įTOS(conf-if-range-te-0/10-11)#no portmode hybridįTOS(conf-if-range-te-0/10-11)#no switchport

The 'default interface te 0/10' command will clear the port configuration, including the VLAN configuration on the port, instead having to remove each setting manually. Select the range of ports that will be used for the Port ChannelįTOS(conf-if-range-te-0/10-11)#no shutdownįTOS(conf-if-range-te-0/10-11)#port-channel-protocol lacpĮnter LACP configuration mode for the interface rangeįTOS(conf-if-range-te-0/10-11-lacp)#port-channel 5 mode activeĪdd Port Channel 5, use 'active' to specify LACP Interface Configuration for LACP Port Channelįirst, remove the current configuration from the port, then add the new port channel. For more information on static port channels, see HOW10365.

VLAN Configuration for Port Channel LAG.

Interface Configuration for LACP Port Channel.

This article discusses the process to create a new port channel or Link Aggregation (LAG) and allowing multiple VLANs on Dell Networking Force10 switches running 9.x firmware.

Youtube how to use a software lag switch